| I saw you post this earlier, but refused to post.......... I see exactly what your pointing to, but my Q is so what? It looks like it's a little off center, that means your not going to get 100% percent cooling because it's off center( if you have a center fed block... LIKE MINE- not yours). YOU will probably be BETTER off with that block you are using, because the cool water will come in CLOSER to the center of the core than if it was centered.
I have nothing against you man really I don't, so I hope you don't take this wrong, but you have been complaining about these issues with the board since even B4 you got it... now you have it and you haven't even hooked it up, but are still looking it over and complaining about it. I don't get it man, if you don't like the board why don't you just take it back instead of going on and on about it's faults?
Your talking maybe 1% cooling difference at most, and with high flow rates it's not (IMHO) going to make hardly any difference at all.
As far as I know blow+suck fan setups don't work any better than just blowing through the rad with a shroud and a good fan......... I know this because I did it, and it didn't do squat, then I learned from other folks who had been doing h2o cooling for a long time, and after some testing they came to the same conclusion..........
Like I said man I hope you don't take this as a slam, it's not intended to be.
This is MY opinion for what it's worth.
O and BTW ET has nothing to do with this, so I don't know what you think he is going to be able to do... actually I think he would laugh.
__________________
|