View Single Post
  #9 (permalink)  
Old 30th April, 2004, 03:55 PM
Gizmo's Avatar
Gizmo Gizmo is offline
Chief BBS Administrator
 
Join Date: May 2003
Location: Webb City, Mo
Posts: 16,178
Send a message via ICQ to Gizmo Send a message via AIM to Gizmo Send a message via MSN to Gizmo Send a message via Yahoo to Gizmo Send a message via Skype™ to Gizmo

On your board, it should be labled 'JP1' and should be near the diagnostic LED display. It is a little plug that sets on a set of three pins, and joins two of the three pins together (rather like the Master/Slave jumper on your IDE drive). Whatever position it is in, move it to the opposite position for a few seconds (e.g. if it is on pins 1 and 2, move it to pins 2 and 3), and then move it back.
Reply With Quote