[hafaphoto]

Hey Karbon86- When I push down on the pins holding the heatsink on the 9800, they do not move, even when using a pen and pushing pretty hard. On my old 9200, the pins move in without much force at all. The heatsink will rotate a few degrees, so I do not think it is held on by anything more than the pins.

I am leary of using more pressure on the pins, because of possible damage to the board. Does anyone have any ideas on this? The only way I can see to get it off would be cut the bottom barb of the pin. Any and all ideas greatly appreciated!

Thanks!

E