View Single Post
  #5 (permalink)  
Old 20th July, 2004, 10:46 PM
Pitch's Avatar
Pitch Pitch is offline
AOA Staff
Join Date: February 2004
Location: The cake is a lie.
Posts: 5,025
Send a message via MSN to Pitch

Ok, deselect your asteroid (Crtl + D) and you will notice a white border around your asteroid.

The best thing to do is take your eraser, set it to "Brush mode" about 15 Pixels wide and go around all the edges. This will neaten the whole thing up for you. It helps to zoom in close when doing this.

Again, make sure you are working on the texture layer.

Once done, it should look something like this.
Attached Thumbnails
Photoshop Asteroid Guide-5.jpg  

XBL/PNS = neolad