[Wolf2000me]

MietmaN

I also have one copper wire (default to 166). The ah32 to ag31 as shown in your pic. The problem is, i don't have the means to check whether i get higher. 2.5-3-3-11 is the highest timing combination i can set without making my memory unstable. I am however seriously considering better memory. My brother, who also has an nforce2 would like some better ram so he's intrested to buy off the Corsair xms from me. That way I could get some kickass TCCD memory. Or BH-5, it seems that memory chip is back from the dead. It will be sold again in the near future.
At any rate, i appear to be "slightly" more stable with Merlins 1T CMD. But the best stable setting i can get is 212.5x12 at mentioned timings. When i go above that in fsb, i get memory instabilities. But it takes longer to crash using Prime. I used to crash within 7 minutes at 215 mhz fsb, which is now 35 minutes. And i don't think it's the controller crapping out. If i lower any timing except for tRAS en CAS i'm not able to post. Of course i'm not entirely certain about that.

edit: I've been wondering for some time. You seem to be able to do 11*220 at 1.65v. It seems to me you can get a lot higher with some more vcore. Unless your cooling is at its limit but i'd be surprised about that. I'm using the SP97 where you're using the SI97. I can do 1.9v without getting my temps higher than 50°C.