buzz,
do you have a + or J board??
make sure and use the latest bios for Rev E. support
try stretching out your timings... say 2.5-4-4-8 and 2.5-4-4-10 and lowering your
vdimm, your LC tccd's might like 2.6-2.7-ish range better as many do.
you might need to use A64 tweaker to do some timing changes that the epox bios doesnt allow or show...
It looks to me that the standard newcastle/winnie
ram settings are not gonna fly with the Vinnie/SD updated mem controller.... and its gonna take some trial and error to figure out what they like.
my 3200 vinnie retail (boxed) should be here monday so I'm flyin by the seat of my pants but have read alot of feedback. It also appears (from other forums) that the SanDiego controller is more sensitive than the venice.
I'm quite sure that with the proper feedback to this forum and ET, the folks writing the bios code will make the appropriate changes in the next bios release.