i had two 120mm fan setting around for awhile not knowing what to do with them. I had bought them to put in front intake and exhaust. Then i realized that my case would need alot of work to get in to fit in the front because the case was made for an 80mm fan with the vent and it didnt ever have screw holes it use latches of some kind. so with that almost undoable for a first time modder i didnt know what to do. so i followed instructions for here and made a top blow hole fan. everthing worked perfectly. i had another 120mm fan so I drilled that in the floor from the bottom. So now my fan setup is as follows 80front and side intake, 120mm rear exhaust and top exhaust and a 120mm bottom case blowing up. my temps have dropped like 6-7 degrees from this. so all is well. since i didnt know what i was gettin myself into at first the cuting might be a little sloppy but i will fix that when ever i get a fan grill so no one cuts off a finger. hopefuly i will have a camera some time soon to take a pic.
