Slight rethink.
It's come to my attention that the board that was previously in that case was quite small. The board I am putting in would interfere with the radiator.
Not a big worry. The radiator is moving to the front of the box. The side radiator hole will now be a window with a Evercool aluminum frame 120 in it.
The left side window will have 3 of the same aluminum frame 120's. The rear will have 2 of the 80mm version of the same fan.
The reservoir is Going to be a small fish tank. Yes, a fish tank.
I found an interesting Betta tank with a bowed front that I am building into the bottom front corner of the left side window. It's 5.5 cubed plus the bow area.
I'm using UV reactive tubing, and a D-tek Fuzion block. Every fan in the box will be intake except the
PSU, obviously. I may go 1 in 1 out on the 80's to stir the air around the Mosfets. I may also add another 80 to the floor of the case to feed the 8800's fan fresh air. I takes 3 80's to move the air of a 120, so I could make all 3 80's Exhaust, and still have 2 120's pushing through the heater core. With these fans that would only be a combined 135 cfm or so, though.
6 laser LEDs light my current PC rather well, so I ordered 20 (5x4) LEDs for this case.
Everything mentioned is ordered. Update in a week or so I guess.