View Single Post
  #16 (permalink)  
Old 5th June, 2002, 12:50 AM
Holst's Avatar
Holst Holst is offline
Join Date: September 2001
Location: Leics UK
Posts: 4,528

Originally posted by chazz469
OK...I understand that it doesn't work the way you want it, but I curious to see what you did and would like some close-ups if that's OK?

Its made from 1/2" copper tubing ans soldered together with YORK solder 90* bends.
Its about 12cm wide and 35cm long and its made from about 3m of tube.
The wire wrapped around is copper earthing wire.
It was cheap to make, no less than £10, proabobly closer to £5.

It gets quite dusty but its not hard to clean.
The YORK solder fittings made soldering very easy, just plug them together with some flux and heat it.

Attached Thumbnails
Finally watercooled-rad1.jpg  
No longer Epox Tech.

Best of luck in the future all my friends.
Reply With Quote