| I used 6/32 standoff's with nylon washers and nuts. The standoff's mount through the board. Next was to place the block in place. I used 1-3/4" 6/32 machine screws with nylon washers and steel springs. I did not like the system that D-tek supplied. Reason: using the above method, once the screws bottom out into the standoff and with everything of equal size or length, you can be 100 percent you have equal pressure on all for corners. In D-tek's method it's up to the user to tighten the thumb nuts to equal pressure. Although using this method you can add or subtract pressure on the chip easier.
__________________
|