Did I kill it?

[gryphyn]

I have been trying to find the 9-10.5 multipliers on my 1600xp.

After a successful unlock I ran the 200x9 for a day or two, then noticed my system wasn't quite as quick as usual, after checking it out WCPUID showed I was running at 7.0 default. I attempted the process several times to no avail. I'm not able to use 9-10.5 mults.
Sometimes after procedure when I check mults it shows "WCPUID" 7-8.5 as 7-8.5 and 9-10.5 as 7.0, 11=11,11.5=11.5, etc.

When I clean everything off "lock" I get the 10.5 back. Am I missing something or should I pay closer attention to a particular bridge on the L1 procedure?

Thanks Gryphyn

[surlyjoe]

I wish I knew, I am haveing a heck of a time with mine as well =P

[kowalski]

Originally posted by gryphyn
I have been trying to find the 9-10.5 multipliers on my 1600xp.

After a successful unlock I ran the 200x9 for a day or two, then noticed my system wasn't quite as quick as usual, after checking it out WCPUID showed I was running at 7.0 default. I attempted the process several times to no avail. I'm not able to use 9-10.5 mults.
Sometimes after procedure when I check mults it shows "WCPUID" 7-8.5 as 7-8.5 and 9-10.5 as 7.0, 11=11,11.5=11.5, etc.

When I clean everything off "lock" I get the 10.5 back. Am I missing something or should I pay closer attention to a particular bridge on the L1 procedure?

Thanks Gryphyn

sounds like the unlock went bad. one of the bridges isn't joined properly. happened to me - 9 would give me 7 etc. if you can, check each bridge with a multimeter. might show you which one is bad, unless the bad contact is below the paint, but it's worth a shot. otherwise just re-do it and be real careful. clean the area thoroughly first with alcohol and an eraser.

it's a ball-ache, but it's gotta be done sometimes...

[gryphyn]

Originally posted by kowalski


sounds like the unlock went bad. one of the bridges isn't joined properly. happened to me - 9 would give me 7 etc. if you can, check each bridge with a multimeter. might show you which one is bad, unless the bad contact is below the paint, but it's worth a shot. otherwise just re-do it and be real careful. clean the area thoroughly first with alcohol and an eraser.

it's a ball-ache, but it's gotta be done sometimes...

At least there is a light at the end of the tunnel Off to try again

Gryphyn