| |||||||
| Register | FAQ | Members List | Calendar | Arcade | Search | Today's Posts | Mark Forums Read |
 |
| | LinkBack | Thread Tools | Rate Thread |
14th November, 2003, 08:08 AM
| ||||
| ||||
| SLK-900U installation I'm curious as to how tight to tighten the 4 spring loaded screws that the secure the HSF to the X back plate? The Thermalright site says tighten them all the way down. How tight are you SLK-900U users going? Laz.
__________________ DFI SLi-D, Opteron 144 @ 2.8Ghz, 4x512MB PDP XBLK, 160GB WD Caviar SE, Benq 1620DW DVD-RW, X1800XT 256MB,Custom WC.       |
|
14th November, 2003, 11:19 AM
| ||||
| ||||
| I don't have this H/S. But on most your not supposed to. They are set up to get the right tension without harming your CPU. Hope this helps!
__________________ "Though all men live in ignorance before mystery, they need not live in darkness... Justice is foundation and ETERNAL." DKE "All that we do is touched by Ocean Yet we remain on the shore of what we know." Richard Wilbur  Subscribers! Ask Pitch about a Custom Sig Graphic |
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Rate This Thread | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Does the SLK-900U fit on the EP-8K3A+? | Lazgoat | EPoX MotherBoards | 1 | 7th April, 2004 02:33 PM |
| SLK-900U Installation | cintrone | Cooling & Temperature Monitoring | 3 | 2nd September, 2003 02:42 AM |
| 8rda3+ & Slk-900u | Geeza | EPoX MotherBoards | 11 | 13th August, 2003 01:41 AM |
| SLK-900U and Zalman NB on an 8RDA3+? | y2kpm | EPoX MotherBoards | 10 | 28th July, 2003 06:06 PM |
| Normal Temps for SLK-900u + 92mm | Shashkastorm | Cooling & Temperature Monitoring | 5 | 1st April, 2003 02:10 AM |
.gif)
