Issue with 8rda+ :-/

[Clipse]

Ok here I go:


With my 1700+ jiuhb 0311 @ 200x9.5=1.9ghz I can boot up at 2volt easily, which I dont need, I only need 1.5volt to boot at that. Anything lower than 1.9ghz also boots up fine at 2volt.

Now the thing is, whenever I boot at more than 1.9ghz, ie. 10x200=2ghz I cant boot at 2volt, I only need 1.575 volt for that tho, but the issue gets worse when I try go higher, I know the chip can do 2.4ghz fine on my older board, but it wont even do 2.1ghz now :/

The higher multiplier I go, with increased Mhz, the less my vcore can go stable, ie. 1.9ghz =1.5-2volt, 2ghz=1.575-1.85volt, 2.1ghz=dont wanna work? not stable at all.

This is very weird for me, system and cpu and northbridge is running VERY cool.

my vdd is at 1.72atm, could it be a result of low vdd?

I would really like a good solid helpfull answer, cause this is driving me up against the wall.

[timbob2469]

Is this a different board than the one in your sig? Northbridge might be very cool (to the touch ?) because of thick thermal tape not allowing heat to get to the heatsink.
bob

[Clipse]

ye same board, it started doing it from the start, and just got worse, I dont know if its the mem yet, could it be?

just taking so long to get my new mem, but even if its not the mem, the board has been modded and will try 2volt vdd soon perhaps.