8k5a2 no post, no codes, nothing. help plz

[Unknownforce]

Hey, just tried to OC my 2000+ and when I attempted to boot it came up with nothing, I then proceeded to undo my OC job, which turned out fine as my 2000+ works on my FiC AD-11 board, which is what I am using now since the Epox crashed on me...

I did absolutely NOTHING to the motherboard in my attempt to OC the CPU, other than plug in the CPU itself when I had bridged the L1 connectors, which is why at first I tried swapping the CPU, with my 1800+ and still nothing, I am now using the 2000+ on my FiC AD-11 and it's rock stable, so the processor obviously works fine.

It powers up fine, all fans spinning, etc etc, I have tried clearing CMOS(jumper), pulling the battery, pulling video(for error beeps, and nothing), pulling RAM(no beeps), pulling CPU(no beeps), booting just the board with only power and speaker plugged into it, and it doesn't do anything.

The onboard display codes do not light up, The board simply does nothing... is there any suggestions as to what might be wrong with it, or what I might be able to press on the KB during power up that might have an effect on it ?

Any suggestions would be greatly appreciated.

[Gizmo]

Wow. No display codes, eh? That doesn't sound good.

Did you do a wire mod on the board (bridge the CPU socket pins with wire) or did you do a jumper mod on the CPU itself?

[Unknownforce]

Just the CPU itself, I did absolutely nothing to the board itself (before attempting to boot with the unlocked chip, after the boot, which was unsuccessful, I attempted to 'revive' her with no success as of yet.), which in my eyes makes no sense as to why it isn't functioning any longer.