AOA Forums

AOA Forums (http://www.aoaforums.com/forum/)
-   EPoX MotherBoards (http://www.aoaforums.com/forum/27-epox-motherboards/)
-   -   8rda+ dodgy bios? (http://www.aoaforums.com/forum/epox-motherboards/22902-8rda-dodgy-bios.html)

ham 8th February, 2004 06:04 PM

8rda+ dodgy bios?
 
Hey, I just got an 8rda+ and an athalon 2800+ chip and installed them both. I have reinstalled windows 2000 and flashed the bios so it recognises the new chip. When it does work it works just fine, the bios recognises the 2800+ and boots normally, but, every so often when I turn on the pc the monitor dosen't come out of standby mode and I have to restart the pc to get it to come on. Even more worrying than that, every few days the bios "forgets" the CMOS settings for the chip and I have to go into bios setup and re-set the fsb speed and multiplyer to get the thing to boot.

oh and I have noticed the usb keyboard led staying on after the power is off but I think I just wired the USB socket up wrong.

is the motherboard faulty or is it something I have done or not done that is causing the problem? any help would be greatly apprieciated, thanks.

TonyCarr 8th February, 2004 06:55 PM

If the bios is not remembering your settings , it could be the little round battery is on the way out .
As far as USB device / keyboard , make sure in bios menu , the legacy and USB selections are enabled .

Good Luck .

ham 8th February, 2004 07:27 PM

yeah, it happened again so I can describe it in more detail. I reset my PC and it diddn't come back on properly, the Hard Drive and power LEDs were on but nothing else was happening. when I restarted it again the boot screen read my processor speed wrong and told me the chip was either new or an overclock had failed and I should reconfigure the CMOS settings. When I went into bios setup the settings were actually right for my chip allready so I saved and exited and when it reebooted it read the correct chip speed and carried on as normal.

I never had to change any settings in bios it had remembered the correct ones it just diddnt read them the forst time round.


Whats up with that???


All times are GMT +1. The time now is 03:26 PM.


Copyright ©2001 - 2010, AOA Forums


Search Engine Friendly URLs by vBSEO 3.3.0