Guide: Custom Case Side Panels - Page 2
Cases, Cooling and Power
Written by booman   
Saturday, 12 August 2006 01:00
Article Index
Guide: Custom Case Side Panels
Page 2
Page 3
Page 4
Page 5
Page 6
Page 7
Page 8
Page 9
Page 10
Page 11
All Pages

Step one:

I started off measuring the sides of my case to an 1/8th of an inch.  I measured all the tab holes so I would know where to make the tabs and I also moved them a 1/4 inch so I will be able to slide the side into place later.  The panel is going to be 16 inches by 17 inches and I am going to bend the edges in for support like real panels. This means I have to ad an extra 1/2 or so to each edge and will need to score and bend them.

Image
(Click for larger image)

 

Here are the measured notches I will be cutting out and bending to fit the holes in the case. They basicly act as a wedge to keep the sides fitting tightly against the case.  They will be filed down and adjusted accordingly to fit the holes perfectly.

Image
(Click for larger image)



 
Don't Click Here Don't Click Here Either