Forum latest

  • It's true..
    A wide latitude is a given to faithful posters at thise olde housee. Not like subtitl...
  • It's true..
    I had completely forgen this thread. Are we to contemplate that our bad behavior (off...
  • It's true..
    This is one heavy movie. If you're in the mood for some gravitas cubed, here it is: ...
Guide: Custom Case Side Panels - Page 4
Cases, Cooling and Power
Written by booman   
Saturday, 12 August 2006 01:00
Article Index
Guide: Custom Case Side Panels
Page 2
Page 3
Page 4
Page 5
Page 6
Page 7
Page 8
Page 9
Page 10
Page 11
All Pages

Step three:

Pre cutting angles. Each corner had to be pre-cut at an angle so that the folded edges would not over-lap. This caused a lot of frustration in the end.

Image
(Click for larger image)



You can see where I have scored the metal and plan to bend it. I had to mark all the edges where I would double up the metal to make it sturdier.  I will bend this same piece up 90 degrees for the back of the case.

Image
(Click for larger image)



 
Don't Click Here Don't Click Here Either