Forum latest

  • It's true..
    A wide latitude is a given to faithful posters at thise olde housee. Not like subtitl...
  • It's true..
    I had completely forgen this thread. Are we to contemplate that our bad behavior (off...
  • It's true..
    This is one heavy movie. If you're in the mood for some gravitas cubed, here it is: ...
Guide: Custom Case Side Panels - Page 6
Cases, Cooling and Power
Written by booman   
Saturday, 12 August 2006 01:00
Article Index
Guide: Custom Case Side Panels
Page 2
Page 3
Page 4
Page 5
Page 6
Page 7
Page 8
Page 9
Page 10
Page 11
All Pages

Step five:

The window - Before I did the 90 degree bends on the "window" side of the case, I had to draw my window and cut out the holes. I started by designing the exact curves in CAD, then printed out the design and cut the window in the paper. Next, I measured the edges of the design with the panel to make sure it is centered. Finally, I used a permanent marker to trace the window design.

Image
(Click for larger image)



 
Don't Click Here Don't Click Here Either