Forum latest

  • It's true..
    A wide latitude is a given to faithful posters at thise olde housee. Not like subtitl...
  • It's true..
    I had completely forgen this thread. Are we to contemplate that our bad behavior (off...
  • It's true..
    This is one heavy movie. If you're in the mood for some gravitas cubed, here it is: ...
Guide: Custom Case Side Panels - Page 7
Cases, Cooling and Power
Written by booman   
Saturday, 12 August 2006 01:00
Article Index
Guide: Custom Case Side Panels
Page 2
Page 3
Page 4
Page 5
Page 6
Page 7
Page 8
Page 9
Page 10
Page 11
All Pages

Step six:

Pilot Holes - The best place to drill pilot holes is anywhere there is a 90 degree angle or acute angles.  Your jigsaw will have problems making real sharp turns so making pilot holes is the best way to acheive this.  Pictured is the bit I used for drilling large enough holes for the jigsaw blade to fit.  Mark the center of the bit with a marker and consider the diameter of the bit to make sure it doesn't cut through
your right angle. Then drill away. Do all the pilot holes at the same time.

(Click for larger image)

Don't Click Here Don't Click Here Either