Forum latest

  • It's true..
    A wide latitude is a given to faithful posters at thise olde housee. Not like subtitl...
  • It's true..
    I had completely forgen this thread. Are we to contemplate that our bad behavior (off...
  • It's true..
    This is one heavy movie. If you're in the mood for some gravitas cubed, here it is: ...
How-To: Homemade spray booth - Page 2
General
Written by Booman   
Saturday, 19 August 2006 13:26
Article Index
How-To: Homemade spray booth
Page 2
Page 3
Page 4
Page 5
Page 6
Page 7
Page 8
Page 9
Page 10
All Pages

Step One

Start with measuring each PVC piece needed to create the top, bottom, and posts.

  • 8 qty. - 60in (5 ft.)
  • 8 qty. - 18in.
  • 8 qty. - 12in.
  • 8 qty. - 6in.

Assemble all the 18-inch, 12-inch, and 6-inch tubes with the corners and "T" junctions like in the picture.  Start with the 12-inch tube in your left hand and slide it into a "T" on its right side.  then slide a 6-inch into the right side of the "T", and next slide another "T" on to the 6-inch tube. Lastly, slide the 18-inch into the right side of the "T".  Make 8 of these exactly the same.

Image
Image
Image
Image


 
Don't Click Here Don't Click Here Either