View Single Post
  #1 (permalink)  
Old 4th April, 2004, 11:16 AM
ckngai ckngai is offline
Member
 
Join Date: April 2004
Posts: 4

4pca3+ serial raid and raid at the same time

hi all,

I am new to this forum and using raid.
I have few questions want to ask.

After I enable SATA raid mode in bios, I found that the normal "CTRL-H" screen disappeared. Then, how could I enter highpoint bios to configure the highpoint IDE?

In addition, what would happen if I load a ghost image of WINXP which have previously installed on a normal IDE harddisk into a highpoint non-raid harddisk. Could it boot up successfully?

THX ALL
__________________
Reply With Quote