View Single Post
  #4 (permalink)  
Old 24th January, 2002, 11:54 PM
Nico67 Nico67 is offline
Member
 
Join Date: December 2001
Location: Australia
Posts: 92

If you look end on at the clip, you will notice that the two outer combs are a little thicker than the rest. This is fine when the clip is for the exact pin count of the chip, but in our case the clip only covers part of the chip.
Answer, file one of the outer combs down to the same thickness as the middle combs. This way the clip will lock onto the chip as it is supposed too.
__________________
Reply With Quote